Summary

Full Project:
https://www.printables.com/model/982474-xtool-p2-corner-square-guide

I purchased a honeycomb bed for my X2 P2, but I found it hard to lay out projects and make them square. The laser is not able to reach 0,0 of the project.

To solve this, I created a square that fits in the corner and brings (0,0) into the laser range.

To Use:
• Cut out a square on the laser
• Place the square in the corner of the laser bed
• Apply tape to X-Offset, Y-Offset
• Label the offset of X,Y to reach (0,0) of the square
• Use plastic panel fasteners to hold the square in place

On my machine the x,y offset for 0,0 was (11,66). I write it on tape incase I need to refine it in the future or want to put origin somewhere else.