Engrave Photo Gift on Wood

Gil avatar
Gil
·
109
869
Design Files (1)
  • On Wood Engrave.xcs
    S1
    • Edited 2025/03/24

    Summary

    A demonstration of the steps taken on my xTool S1, XCS, and finishing the engraving of an image on a wood surface. The material is wood from Michaels to engrave on.  Stand was purchased from there as well.  The setting for my final engraving is: for the image 17% power/75 mms(Take your time to allow the laser to work and do not risk over-burning the material) For the text I used 64% power/128mms both at 180 LPI.  I hope this helps.  leaning forward while working out of the garage.

    Production Info

    Instruction
    Not included
    Application scenario
    Laser
    Software
    xTool Creative Space
    Machine & processing module
    xTool S1
    20W
    Compatible xTool Machine
    Guidelines for using compatible machines
    xTool M1
    5W, 10W
    xTool F1 Ultra
    20W
    xTool P2
    55W
    xTool M1 Ultra
    10W, 20W
    xTool P2S
    55W
    xTool F1
    10W
    xTool S1
    10W, 40W
    xTool D1
    5W, 10W, 20W
    xTool D1 Pro
    5W, 20W, 10W, 40W
    Material used
    3mm Basswood Plywood
    Wood Material 1/2" wood with Bark - reacts the same as 3mm Basswood plywood, Frame stand, Minwax Polycrylic Topcoat - Clear Gloss.
    Total time
    180 min

    Setting

    Setting 1
    Setting 2
    Setting 3
    Setting 4
    Setting 5
    Setting 6
    Setting 7
    Setting 8
    Setting 9
    Setting 10

    License

    CC BY-NC
    This license allows reusers to distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, and only so long as attribution is given to the creator.

    Do you like this project?

    You may also like

    gift
    Newcomer gifts